3COM certification 3COM
Adobe certification Adobe
Apple certification Apple
Avaya certification Avaya
BEA certification BEA Systems
Business Objects certification Business Objects
Check Point certification Check Point
Cisco certification Cisco
Citrix certification Citrix
CIW certification CIW
CompTIA certification CompTIA
CWNP certification CWNP
EC-Council certification EC-Council
EMC certification EMC
Exam Express certification Exam Express
Exin certification Exin
F5 Networks certification F5 Networks
HDI certification HDI
HP certification HP
Hitachi certification Hitachi
IBM certification IBM
ISC certification ISC
ISEB certification ISEB
Juniper certification Juniper Networks
Lotus certification Lotus
LPI certification LPI
Microsoft certification Microsoft
Mile2 certification Mile2
Network Appliance certification Network Appliance
Nortel certification Nortel
Novell certification Novell
Oracle certification Oracle
PMI certification PMI
RedHat certification RedHat
SAIR certification SAIR
SAS certification SAS Institute
SNIA certification SNIA
Sun certification Sun
Sybase certification Sybase
Symantec certification Symantec
Teradata certification Teradata
Tibco certification Tibco
Veritas certification Veritas
VMware certification VMware
All Exams

CompTIA HT0-201 Exam - PassITexam.com

Free HT0-201 Sample Questions:

1. Which of the following would be used to determine where a break in a wire is located?
A. Analog Toner
B. Time Domain Reflectometer (TDR)
C. Digital Multi-meter (DMM)
D. Digital Signal Generator
Answer: B   

2. Which of the following cabling would be MOST commonly used with analog volume controls?
A. Shielded twisted pair (STP)
B. RJ-59
C. 16/4 solid conductors
D. 14/4 stranded
Answer: D   

3. Which of the following home control protocols utilizes an existing line voltage electrical wiring infrastructure for communication and control? (Select TWO)
A. Z-Wave
B. UPB
C. ZigBee
D. X10
E. Power over Ethernet (PoE)
Answer: BD   

4. A user has multiple satellite receivers; one of the rooms is not receiving a signal while all other rooms are receiving a signal.  Assuming the receivers are working correctly, which of the following should be tested FIRST to find the problem?
A. Dish
B. Multi-switch
C. Diplexer
D. Grounding block
Answer: B   

5. An end of line resistor is used on a smoke detector to:
A. determine if a smoke detector fails.
B. balance the line for proper operation.
C. provide a closed circuit to the fault relay.
D. lower false alarm occurrences.
Answer: C   

6. For proper equipment protection, all integrated equipment should:
A. carry their own ground.
B. share a common ground.
C. be grounded at each controller location.
D. never be grounded in a single location.
Answer: B   

7. Which of the following kinds of internal wiring configuration is required for typical key service unit (KSU) phone systems?
A. Star topography
B. Daisy-chained topography
C. Media-bus topography
D. Token-ring topography
Answer: A   

8. Which of the following is the standard for RF video distribution over coaxial cable?
A. 50 ohms
B. 59 ohms
C. 75 ohms
D. 100 ohms
Answer: C   

9. When installing a security system, which of the following connectors would be used to connect the security system to the telephone service demarcation?
A. RJ-31x
B. RJ-11
C. RS-232
D. DB-9
Answer: A   

10. A paging adapter is used to:
A. interface a telephone system to an external paging system.
B. match the impedance of the external paging speaker.
C. supply ring voltage to the external paging system.
D. simulate a single line telephone handset.
Answer: A